15
Do not clean the air filter with gasoline or other highly volatile petroleum product.
Diesel fuel or kerosene would be preferred but caution should still be taken. Hot
soapy water works well.
NOTE:
The Cobra is equipped with a special designed Air box. It is very important to
keep the air filter clean and properly oiled with high quality water-resistant foam
filter oil. It’s very important to oil your filter consistently each time because varied
amounts of oil will change your carburetor jetting.
NOTE:
Make sure you change or clean your filter after each moto. We recommend
carrying three or more filters in your toolbox.
•
1 for practice
•
1 for each moto
M6: Fork Oil Replacement
Tools required
•
5 & 6 mm Allen wrench
•
19 mm wrench or socket (two required)
•
Spring clip remover
Disassembly
1. Remove the front wheel.
2. Remove the fork legs from the triple clamps.
3. Perform the following on one leg at a time.
4. Using your hands, remove the black rubber plug from the top of the fork leg
exposing the white plastic cap.
5. Secure the fork leg assembly in a vice by gripping the leg across the flats
through which the axle bolt goes through.
6. Depress the white plastic cap inwards (down) and remove the wire spring clip
from its groove.
7. Remove the white cap, the fork spring preload sleeve, and the fork spring.
NOTE:
Depressing the fork leg will facilitate removing the white cap.
8. The fork can now be turned upside down and drained.
Assembly
1. Fill the leg with 200 cc (6.8 oz) 20 wt fork oil.
2. Standard fork oil level is 70 mm (2.75”) from the top edge with the fork
collapsed.
