6.
Check proper clutch engagement before and after each ride. If the clutch is
engaging properly DO NOT feel the need to take the clutch apart to;
measure the spring stack, clean the stack, replace the springs, etc... Cobra
has worked real hard to make a clutch that is low maintenance and so only
take it apart if it NEEDS to be maintained.
Replacing Transmission / Clutch Lubricant
Tools needed:
•
Minimum of 235 ml (8 oz)
Cobra Venom 3 Shoe Clutch Milk
(Part #
MCMUGF01).
NOTE:
Up to 350ml (12 oz) can be applied without hurting performance.
Procedure:
1. Begin this procedure with a bike that has been ridden more than 5 minutes
but less than 10 minutes. It is desired to have the engine warm enough so
that the oil is ‘runny’ but not so hot that there is risk of being burned by the
engine or the oil.
Hot oil and hot components on the motorcycle may cause burns.
2. Lean bike against something or set on stand with oil drain hole.
3. Remove the oil drain plug located on the right side of the engine, on the
clutch cover, near the brake lever (figure 1).
Figure 1
4. After it has drained, reinstall the plug, being sure that the gasket is in place.
5. Reapply oil from oil fill plug 235 cc (8.0 oz)
Cobra Venom 3 Shoe Clutch Milk
thru the oil fill plug.
12
Summary of Contents for 2008 ECX50
Page 1: ......
