Cobra 4600 CAN, Installation Manual

INSTALLATION MANUAL 4600 CAN/PLIP

18

7. - 

PROGRAMMABLE 

FUNCTIONS

.

To activate them refer to the “FUNCTIONS PROGRAMMING” table.

7.1 - Activation and volume adjustment of the audible arming and disarming signalling.

This function allows to activate a short duration audible signal to con

fi

 rm the system’s arming (1 beep) and disarming 

(2 beeps). 

7.2 - Passive arming.

The system will automatically arm after 30 s the ignition key has been switched off and the driver side door has been 
opened and closed, so only 30 s after the driver has left the vehicle.

7.3 - Auto re-arming.

The system will automatically re-arm after 115 s, it has been disarmed and no one door has been opened (nobody 
gets on the vehicle).

7.4 - Auto re-arming with doors locking.

As for auto re-arming, but doors will lock (if the CDL connections have been made).

7.5 - Passive engine starting inhibition.

The starting inhibition becomes active after 115 s the engine has been switched OFF. The cranking inhibition is immediately 
deactivated if the Driver Card is detected or when a correct emergency PIN Code has been digit on the emergency 
panel. This functionality is totally independent from the other ones.

7.6 -  Manual or automatic comfort window closing with Cobra remote control.

This is a native function of the vehicle, so at 

fi

 rst check if it is available. By keeping pressed the Cobra remote control 

pushbutton “A” you can close the windows from a distance in manual mode. If not you can ask your installer to 

fi

 t an 

additional module which allows the closing of windows by pressing and releasing the button “A” in automatic mode. 

Warning

: for safety reasons we recommend to close the windows remaining close to the vehicle.

7.7 - Anti hi-jacking.

This function prevents the vehicle for being stealing while driving. It has been studied to also guarantee the driver safety. 
If the driver is not recognized by the system he will be considered as not authorized to drive the vehicle. The system will 
generate an alarm sequence and it will prevent the vehicle to start again after it has been switched OFF.

During the normal usage of the vehicle the driver is recognized by the system in two ways:

-  

automatic

 by the Driver Card matched to the system (if provided);

-  

manual

 by entering with the emergency panel pushbutton the 

fi

 rst two digits of the PIN Code.