Cobra 4600 CAN, Installation Manual

INSTALLATION MANUAL 4600 CAN/PLIP

5

4. - 

HOW TO PREPARE THE PIN CODE CARD.

Remove the separate PIN Code label from the back of the system main unit and place onto the supplied PIN Code Card.

www

.cobra-at.com

PLACE HERE THE PIN

CODE LABEL

PERSONAL  IDENTIFICATION

CODE

4C4415A2A

S/N  0003 050524

PIN

CODE

1122

5. - INSTALLATION PROCEDURE.

System’s component positioning.

As much as the components of the system will be placed in secure and dif

fi

 cult to access positions as higher the 

protection level will be.

WARNING

:  each element must be positioned so that it does not interfere with moving parts.

Alarm unit. 

It must be 

fi

 tted inside the vehicle far away from heating sources, paying attention to keep the main connector oriented 

down.

Siren.

It can be installed in the engine bay as inside the vehicle far away from heating sources paying attention to keep the 
main connector oriented down.

Ultrasonic volumetric sensor.

The ultrasonic transducers  must be 

fi

 xed to the top of the A pillars pointed towards the rear window or to the top of the 

C pillars pointed towards the windscreen. Their orientation should be as much as possible parallel to the side windows.

Emergency LED/control button 

It must be 

fi

 tted on the dashboard with its LED in a  in sight position. The pushbutton should be easily accessible by 

the driver.

Bonnet pushbutton.

The installation of the supplied pushbutton is required if the vehicle is not yet equipped with the original one. The speci

fi

 c 

vehicle CAN/PLIP installation sheet supplies this info.