Page 8
For technical questions, please call 1-888-866-5797.
Item 57647
Camera Adjustment
1. Using an Allen wrench (sold
separately), loosen the Position
Screws (one on each side) and
rotate the Camera as needed
so that the recorded image is
properly orientated. Once aligned,
tighten the screws securely.
2. Loosen the Vertical Screw and tilt the
Camera up or down. Once the Camera
is aligned, tighten screw securely.
3. Loosen the Horizontal Screw
and pan the Camera left or right.
Once the Camera is aligned,
tighten screw securely.
Position
Screws
Vertical
Screw
Horizontal
Screw
Cable Connection
Using the RJ45 Cable, connect
the Camera to the NVR.
CAUTION!
Route the cable so
as to avoid a tripping hazard.
Note:
The RJ45 cable carries power
from the NVR to the Camera and
video from the Camera to NVR.
Note:
The Service Cable is for factory
service only. Not for normal use.
CAM7
CAM7
CAM5
CAM5
CAM8
CAM8
CAM6
CAM6
CAM3
CAM3
CAM4
CAM4
CAM1
CAM1
CAM2
CAM2
WAN
WAN
AUDIO OUT
AUDIO OUT
VGA
VGA
48V
48V
NVR
Camera
RJ45 Cable
Service Cable
Camera Inputs
RJ45 Cable, 60ft.