1.
Turn on the unit and adjust
audio volume by rotating the
ON-OFF/VOLUME CONTROL DIAL
clockwise (away from you).
2.
You will see
“TESTING”
appear in
the display, 3 beeps will sound, then
“SYSTEM READY”
will appear
indicating that the power is on.
3.
The display will cycle through the
user mode settings (SmartMute
™
and
City/Highway status) for approximately
1 second each.
4.
Start-up is complete when the
display continuously shows the
current compass direction (N, NE,
E, SE, S, SW, W, or NW) plus
single letters indicating current user
mode settings (c = city mode, h =
highway mode, s = SmartMute
™
on).
NOTE:
In some vehicles, power is supplied
to the cigarette lighter even while the ignition
is off. If this is the case with your vehicle,
you should turn off or unplug your ESD-9560
when parking for lengthy periods.
Dashboard Mounting
1.
Place the detector on the dashboard
to find a location where the unit has
a clear, level view of the road. The
angle can NOT be adjusted after
mounting.
2.
Remove the paper backing from one
side of the hook-and-loop fastener.
3.
Attach the pad to the dashboard at
your chosen location and remove the
other paper backing.
4.
Attach the detector to the hook-and-loop
fastener. You can remove and reattach
the unit as often as you like.
5.
Plug the power cord into the detector.
6.
Plug the cigarette lighter adapter on
the power cord into your vehicle's
cigarette lighter.
1
I N S TA L L AT I O N
5
2
O P E R AT I O N •
G E T T I N G S TA RT E D
4
U
L
T
R
A
N W
B r i g h t
c
s
N W h
Testing
System Ready
