Cobra microTALK CXR925, Owner'S Manual

Customer Assistance Warranty

Introduction

15

Operation

14

Mode Functions

Operation

6.

 Choose one of the following:

a.

  Press the 

Channel Up

 or 

Channel Down

button to select a CTCSS privacy code  

(01 through 38) for the channel.

b.

  Press the 

Lock/Enter

 button to 

switch from CTCSS to DCS. The DCS  

icon and privacy code numbers will  

flash on the display. The 

Channel Up

or 

Channel Down

 button can then be 

used to select a DCS privacy code  

(01 through 104) for the channel.

If “OFF” flashes in place of the privacy  

code numbers, a privacy code is  

already set in the opposite (CTCSS  

or DCS) system. Press the 

Channel Up

or 

Channel Down

 button to cancel 

the opposite code and select a privacy 

code from the active system for the 

selected channel.

7.

 Choose one of the following:

a.

  Press the 

Lock/Enter

 button to enter 

the channel/privacy code in the selected 

memory location. Radio then proceeds to 

next Memory location, which will blink. 

b.

  Press the 

Mode

 button to 

enter the channel/privacy code in  

the selected memory location and  

proceed to other functions on the channel/

privacy code displayed  

before you entered mode functions.

c.

  Press the 

Talk

 button to enter the channel/

privacy code in the selected memory 

location and exit mode functions. Upon 

release of the 

Talk

 button, the 

radio will enter 

Standby

 mode on the 

channel/privacy code just entered.

10 Memory Locations 

•

Your microTALK

®

 radio has

 10 Memory

Locations

 for storing 

your most frequently used channels and channel/privacy code 

combinations. These 

Memory Locations

 can be selected individually 

or can be scanned. (See page 22 for memory location scan.)

To program a memory location:
1.

  Press the 

Mode

 button until the 

Memory

 icon and the memory location 

flash on the display.

2.

  Press the 

Channel Up

 or 

Channel Down

button to select the memory location  

(0 through 9).

If a location has been programmed 

before, its associated channel/privacy 

code will be shown on the display.

3.

  Press the 

Lock/Enter

 button to enter 

a new memory location or edit an already 

programmed memory location. The channel 

numbers will flash on the display.

4.

  Press the 

Channel Up

 or 

Channel Down

button to select a channel (1 through 22).

5.

  Press the 

Lock/Enter

 button. 

The CTCSS icon and privacy code  

numbers will flash on the display.

Memory Icon

Mode Button

LI 7300

Channel Button

LI 7300

Lock/Enter Button

CXR925_MANL.indd   14-15

7/15/09   5:12 PM