Cobra microTALK CXR950, Owner'S Manual

Intro

Operation

Customer
Assistance

Warranty

Notice

Main Icons

Secondary Icons

Intro

Operation

Customer
Assistance

Warranty

Notice

Main Icons

Secondary Icons

Customer Assistance

Warranty

Introduction

15

Operation

Intro

Operation

Customer
Assistance

Warranty

Notice

Secondary Icons

14

Mode Functions

Operation

Intro

Operation

Customer
Assistance

Warranty

Notice

Secondary Icons

6.

Choose one of the following:

a.

Press the 

Channel Up

or 

Channel Down

button to select a CTCSS privacy code 
(01 through 38) for the channel.

b.

Press the 

Lock/Enter

button to 

switch from CTCSS to DCS. The DCS 
icon and privacy code numbers will 
flash on the display. The 

Channel Up

or 

Channel Down

button can then be 

used to select a DCS privacy code 
(01 through 104) for the channel.

If “OFF” flashes in place of the privacy 
code numbers, a privacy code is 
already set in the opposite (CTCSS 
or DCS) system. Press the 

Channel Up

or 

Channel Down

button to cancel 

the opposite code and select a privacy
code from the active system for the
selected channel.

7.

Choose one of the following:

a.

Press the 

Lock/Enter

button to enter 

the channel/privacy code in the selected
memory location. Radio then proceeds to
next Memory location, which will blink. 

b.

Press the 

Mode

button to 

enter the channel/privacy code in 
the selected memory location and 
proceed to other functions on the
channel/privacy code displayed 
before you entered mode functions.

c.

Press the 

Talk

button to enter the

channel/privacy code in the selected
memory location and exit mode functions.
Upon release of the 

Talk

button, the 

radio will enter 

Standby

mode on the

channel/privacy code just entered.

10 Memory Locations

•

Your microTALK

®

radio has

10 Memory Locations

for storing 

your most frequently used channels and channel/privacy code
combinations. These 

Memory Locations

can be selected individually

or can be scanned. (See page 22 for memory location scan.)

To program a memory location:

1.

Press the 

Mode

button until the 

Memory

icon and the memory location 

flash on the display.

2.

Press the 

Channel Up

or 

Channel Down

button to select the memory location 
(0 through 9).

If a location has been programmed
before, its associated channel/privacy
code will be shown on the display.

3.

Press the 

Lock/Enter

button to enter 

a new memory location or edit an already
programmed memory location. The channel
numbers will flash on the display.

4.

Press the 

Channel Up

or 

Channel Down

button to select a channel (1 through 22).

5.

Press the 

Lock/Enter

button. 

The CTCSS icon and privacy code 
numbers will flash on the display.

Memory Icon

Mode Button

LI

73

00

Channel Button

LI

73

00

Lock/Enter Button