Intro
Operation
Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Customer Assistance
Warranty
Introduction
19
Operation
Intro
Operation
Customer
Assistance
Warranty
Notice
Secondary Icons
18
Mode Functions
Operation
Intro
Operation
Customer
Assistance
Warranty
Notice
Secondary Icons
During channel scan (while receiving an incoming transmission),
you can choose from the following:
a.
Press and hold the
Talk
button to communicate on
that channel. Your radio will remain on that channel
and return to
Standby
mode.
b.
Press the
Channel Up
or
Channel Down
button to
resume scanning channels.
If you press the
Talk
button while scanning, but more than
10 seconds after receiving a transmission, you will transmit
on the channel on which you last received a transmission.
This will return the radio to
Standby
mode.
If you do not press any button within 10 seconds after
receiving a scanned transmission, your radio will automatically
resume scanning channels.
During channel scan (while not receiving a transmission),
you can choose from the following:
a.
Press and hold the
Talk
button to communicate on the
channel or channel/privacy code that was displayed before
you entered mode functions or the channel on which, during
scanning, you last received a transmission. This will then
return the radio to
Standby
mode.
b.
Press the
Mode
button to proceed to set privacy code scan
on the channel that was either displayed before you entered
mode functions or on which, during channel scanning, you
last received a transmission (see page 20 for further details).
c.
Press the
Lock/Enter
button to return to
Standby
mode
on the channel/privacy code that was displayed before you
entered mode functions or the channel on which, during
scanning, you last received a transmission.
Channel Scan
•
Your microTALK
®
radio can automatically scan channels.
To scan channels:
1.
Press the
Mode
button until the
Scan
icon and the channel numbers
flash on the display.
2.
Press the
Channel Up
or
Channel Down
button to begin scanning channels.
The radio ignores specific privacy
codes while scanning channels.
The
Scan
icon will continue to be displayed
when scan is
on
. Your radio will continue to
scan all channels and stop if an incoming
transmission is detected. Your radio will
remain on that channel for 10 seconds.
While setting channel scan, if you do not
press any buttons for 15 seconds, your radio
will automatically return to
Standby
mode on
the channel or channel/privacy code displayed
before you entered mode functions.
Scanning Channels
Mode Button
LI
73
00
Channel Button
