Set CTCSS Privacy Codes
•
To select a CTCSS privacy code:
1.
After selecting a channel, press
the
Mode/Power
button until the
CTCSS
icon
appears and the small numbers next to the
channel number flash on the display.
If DCS is turned
on
at the channel
selected, the display will flash the
CTCSS icon and “OFF.” To switch from
DCS to CTCSS, press the
Channel Up
or
Channel Down
button while the
display is flashing “OFF.” The display
will then show the small numbers
flashing and you will then be able
to proceed to step 2.
2.
Press using the
Channel Up
or
Channel Down
button to select a privacy code. You can hold
the
Up
or
Down
button for fast advance.
3.
When your desired CTCSS privacy code is
displayed, choose one of the following:
a.
Press the
Mode/Power
button to enter the
new setting and proceed to other functions.
b.
Press the
Lock
button to enter the new
setting and return to
Standby
mode.
c.
Do not press any buttons for 15 seconds
to enter the new setting and return to
Standby
mode.
Customer Assistance
Warranty
Introduction
Operation
Using Your Radio
Operation
6
7
Mode/Power
Mode/Power
Privacy Code
Channel Button
Scrolling Through the Mode Function
•
By scrolling through the
Mode
function, you will be able to
select or turn
on
preferred features of your microTALK
®
radio.
When scrolling through the
Mode
function, your radio features
will be displayed in the same predetermined order:
Set CTCSS Privacy Codes
Set DCS Privacy Codes
Set Vox On/Off
Set Vox Sensitivity
Set Channel Scan
Set CTCSS Privacy Code Scan
Set DCS Privacy Code Scan
Set Call Tones
Set Roger Beep On/Off
Privacy Codes
•
Your microTALK radio incorporates two advanced coded squelch
systems that can help to reduce interference from other users
on any given channel. CTCSS (Continuous Tone Coded Squelch
System) provides 38 privacy codes and DCS (Digitally Coded
Squelch) provides 83 privacy codes. This provides a total of 121
Privacy Codes
. Either system can be used on all channels, but both
systems cannot be used on the same channel at the same time.
To successfully communicate using a privacy code, both
the sending and receiving radios must be tuned to the same
channel and to the same privacy code system (CTCSS or
DCS) and privacy code number. Each channel will remember
the last privacy code system and number you select.
The privacy code 00 is not a privacy code, but allows all
signals to be heard on a channel that is set to 00 on both
the CTCSS and DCS systems.
Nothing
Comes Close to a Cobra
®
