Installation
continued
Installation
7
8
MOUNT
To install the
Adhesive Windshield Mount
,
slide the dash cam onto the mount. Remove
protective film from camera lens and display.
Find the spot on your windshield where
you would like to mount the camera and
confirm the placement. Reminder, this is an
adhesive mount, so it is important to mount
correctly the first time. Next, peel the plastic
film off the 3M adhesive and press the
mount FIRMLY onto the windshield.
For a View of the Road Behind You
Connecting FV-RV1 Rear Cam
Connect Extension Cable to the Video Input
Port on the Dash Cam and run the cable
along the floor of your car. Connect the
Extension Cable to the Rear Camera and
attach to the vehicle’s back window. Please
orient the rear camera so it faces out the
windshield as shown here.
Connecting FV-EV1 External Cam
Connect Extension Cable to the Video Input
Port on the Dash Cam. Use the included
cable routing clips to route the extension
cable to the desired mounting location.
Mount the camera using the mounting
screws or adhesive pad as needed. Screw
mounting is recommended for the most
secure hold.
POWER
Plug one end of the supplied 12V Vehicle
Power Adapter into your vehicle’s cigarette
lighter, and the other end into the micro
USB port. The unit will automatically turn on
and start recording. To manually power on
the device
PRESS AND HOLD
the Power
button until the display activates.
Note:
A Hardwire Kit is available at
www.cobra.com for a more permanent
installation that allows for discrete routing of
the power cable and recording while your
vehicle is off.
DRIVE!
Your dashcam is designed for easy operation. After powering the camera will instantly begin loop
recording. When the MicroSD Card is full the oldest footage will be deleted to make way for the new. If
you witness something that you do not want deleted simply press the Emergency Record button and it
will be saved.
Connecting the FV-CV1 Cabin View Cam
Simply plug the Cabin View Cam into
the side of the SC400D and tilt to adjust
recording angle.
