Settings
Your Detector
Settings
Your Detector
IntelliMute Pro
IntelliMute Pro
prevents detection by radar detector detectors (RDDs) such
as VG-2, Spectre I and Spectre IV+ when traveling at slower speeds. It is
intended for use by experienced users only.
When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute
activation point, your detector’s radar detection circuits are turned Off to
prevent detection by RDDs.
Before IntelliMute Pro can be turned On, you must have turned On and Set
the IntelliMute activation point. (See pages 9 through 11.)
To Turn IntelliMute Pro On
While no signal
is being detected,
press and hold both
the
IntelliMute
and
City
buttons for four
seconds.
Tone
Voice
Visual Display
Two beeps
IntelliMute Pro On
i
blinks continuously
in the display after
IntelliMute Pro On
blinks
To Turn IntelliMute Pro Off
Press and hold both
the
IntelliMute
and
City
buttons for four
seconds.
Tone
Voice
Visual Display
One beep
IntelliMute Pro Off
None, after
IntelliMute Pro Off
blinks
CAUTION
When IntelliMute Pro is On,
NO
radar signals will be detected and
NO
alerts will be given at RPMs
below
the IntelliMute activation point.
NOTE
The arrow up or down will continue
to show that engine RPMs are
above or below the user-set value.
Nothing
Comes Close to a Cobra
®
13
12 English
Voice/Tone Setting
You can set your detector to sound alerts with either a
Voice
or a
Tone
.
You can change settings by using the
Mute
button.
In Voice Alert mode, you will first hear several tones, then a voice message
announcing the type of signal detected, followed by more tones. In Tone Alert
mode, you will hear the tones only. The factory setting is Voice Alert mode.
Mute Button
Press and hold for
two seconds
To Change From Voice Alert to Tone Alert
While no signal
is being detected,
press and hold
the
Mute
button
for two seconds.
Tone
Voice
Visual Display
One beep
Tone Alert
None, after
Tone
blinks in
the display
To Change From Tone Alert Back to Voice Alert
While no signal
is being detected,
press and hold
the
Mute
button
for two seconds
again.
Tone
Voice
Visual Display
None
Voice Alert
None, after
Voice
blinks in
the display
IntelliMute Pro On
i h
IntelliMute Button
City Button
Press and hold both
buttons simultaneously
XRS9570_MANL.indd 12-13
8/24/10 9:25 AM
