23
OPERATION
CHANNEL SCAN
24
OPERATION
CHANNEL SAVER/MEMORY CHANNELS
CHANNEL SAVER FEATURE*
Automatically retains the last channel used when CB is turned off and
returns you to that channel when CB is turned back on.
*For this feature to function, the red wire must be directly connected to
either:
1. Positive (+) battery terminal.
2. Connection on the fuse-box that is always live.
See installation section for details.
NOTE: If the UK75ST is connected to a constant 12-volt source, leaving it
switched on after the engine is turned off may drain the car battery.
SAVING CHANNELS
IN MEMORY
1. Select desired channel to
store in memory.
2. Press and release the
Memory key.
3. Press and hold the
desired Memory Location
key to lock channel into
memory.
4. The Memory Location
will appear on
the display.
ALL-CHANNEL SCAN
1. Set Squelch Control (SQL)
to the DSS (Desired
Squelch Setting).
*See page 16 to set DSS.
2. Press and release Scan
key*. When activity is
found on a channel,
scanning will stop.
* Unit will begin to scan all 40
channels within selected band
(EU or UK). Press and hold
SCAN key for 2 seconds.
3. Scan icon will apear.
4. Press any key to stop
scanning sequence.
N OT E . The UK75ST will stop scanning and monitor a channel when it
r e c e ives an incoming transmission. Five seconds after the
t ransmission stops, the UK75ST will resume the scanning function.
To resume scan during REC mode, press Scan key again twice.
UK75ST-English-UK.qx 6/15/99 3:57 PM Page 28
