EasySet Programming
Nothing
comes close to a Cobra
®
7
EasySet Programming
6
English
EasySet Programming
•
All user mode settings on your detector can be changed by using
Program mode. When changing the settings, please keep in mind:
■
Buttons can have multiple functions.
■
All settings will be stored in memory when the power is
turned off and recalled when the power is turned back on.
The procedure for using Program mode is shown on page 7.
NOTE
You cannot enter Program mode during an alert. The unit will not detect
signals while in Program mode. During programming, if no buttons are
pushed for 10 seconds, the unit will automatically exit Program mode
and save the last settings.
Programming User Modes
The tables on pages 8 through 9 show you how to program all user modes
and the settings you can choose from.
NOTE
On the following pages, you will find more detailed
explanations of each setting.
See page 14 for instructions on setting the IntelliMute activation point.
See page 16 for instructions on calibrating the compass.
See page 21 for instructions on using SmartPower.
Intro
Operation
Customer
Assistance
Warranty
Notice
Secondary Icons
Your Detector
Intro
Operation
Customer
Assistance
Warranty
Notice
Secondary Icons
Your Detector
Program/Mute Button
Press and hold/Press and release
Select/Dim Button
Press and release
Set/City Button
Press and release
To use Program Mode
Press and hold the
Program/Mute button
for two seconds.
Tone
Visual Display
Three beeps
Program will appear.
Then brief programming
instructions will scroll through
the display three times.
While the programming
instructions are
scrolling, press and
release the Select/Dim
button to cycle through
the user modes.
One beep with
each button press
As each mode is displayed,
the current setting for that
mode will be shown.
With the user mode you
wish to change displayed,
press and release the
Set/City button to
change the setting.
To move to the next
selection, press the
Select/Dim button again.
One or two beeps,
depending on your
selection
The setting you select will
be shown.
When you have finished
programming any or
all of the user modes,
press and release the
Program/Mute button
to exit Program mode.
Or simply wait
10 seconds without
pushing any buttons.
One beep
When you exit Program
mode, the new setting will
automatically be saved and
EXIT PROGRAM and Settings
Saved! will appear in the display.
EXIT
PROGRAM
PROGRAM
Settings
Saved!
Intro
Operation
Customer
Assistance
Warranty
Notice
in Icons
condary Icons
Intro
Operation
Customer
Assistance
Warranty
Notice
in Icons
condary Icons
