Pairing with your Baha Sound Processor
Switch off your Baha Sound Processor
by opening the battery door.
1
Press the white pairing button on the Phone Clip
once using the tip of a pen or similar object.
3
Switch on
Remove cap
Switch on your Phone Clip and remove
the silver cap.
2
While pairing mode is active, switch on your
sound processor by closing the battery door.
5
The LED will flash yellow every two seconds and the
Phone Clip will now be in pairing mode for 20 seconds.
4
Successful pairing will be indicated by an
audible melody played in the sound processor.
6
Pairing with your mobile phone
Switch on
Remove
cap
Switch on your Phone Clip and remove the silver cap.
1
Make sure your mobile phone’s Bluetooth
®
function is
switched on. Refer to your mobile phone user guide or
visit www.jabra.com for instructions.
2
LED
Press the blue Bluetooth pairing button on the Phone Clip
once to activate the pairing mode for 2 minutes. During
pairing the LED will turn blue.
3
On your mobile phone search for new Bluetooth devices and
select “Hearing Aid Phone” from the list.
4
If your mobile phone asks for a passcode,
enter “0000” (four zeros).
5
Your Phone Clip is now paired with your mobile phone.
If your mobile phone asks which Bluetooth service you wish
to enable, select “Headset”.
6
