UCR-4285 UNIVERSAL REMOTE CONTROL
12
•
Programming a macro (example: Using the ‘
Last
’ button to switch from ‘
TV
’ mode to ‘
SAT
’ mode and
select channel 801):
1- Press ‘
TV
’ to select the mode in which you want to execute the macro.
2- Press and simultaneously. Do not release them until the indicator has flashed several times to
confirm.
3- Press ‘
9 9 5
’. The indicator flashes several times.
4- Press ‘
Last
’ to select the button you want to assign to the macro.
5- Now press the desired series of commands: ‘
TV
’, ‘
AV
’, ‘
SAT
’, ‘
8 0 1
’.
6- Press ‘
Enter
’ to save the macro, and don’t let go until the indicator flashes several times.
•
Executing a saved macro: Press the button to which the macro is assigned for 1.5 seconds (in the
macro programmed above: ‘
Last
’).
•
Cancelling a macro (example: the macro programmed above):
1- Press ‘
TV
’ to select the mode in which the macro was programmed.
2 Press and simultaneously. Do not release them until the indicator has flashed several times to
confirm.
3- Press ‘
9 9 5
’. The indicator flashes several times.
4- Press ‘
Last
’ to select the button assigned to the macro.
5- Press ‘
Enter
’. Do not release them until the indicator has flashed several times.
•
A macro can contain a maximum of 32 pressed buttons.
•
Assign a macro to a button you do not use, because the macro writes over the pre-programmed code.
•
A macro can also be used to switch lights on and off (e.g. press a single button to switch off your Home
Theatre and switch on the lights near the TV).
•
If a button on the original remote control must be held for several seconds to activate a particular
function, this function cannot be programmed in a macro.
Remarks
Reminders
•
This product is a combination of an infrared remote control and a radio-frequency transmitter.
Remote control: Controls numerous multimedia devices (TV, Stereo, DVD, MediaCenter PC etc.) in the
same manner as the original remote control.