28
SETTINGS
Restrictions
Max temp.
Access contr.
To adjust the setpoint temperature to the
temperature registered in the room if you see a
difference after several hours' heating.
The calibration value is between -3° C below
and +3° C above the temperature set.
E.g.: if the room T° = 18°C and the set T° = 20°C,
select -2.0°
.
General
Function config
T° calibration
Sound
To activate or deactivate the key sounds.
To limit access to the controls. You may choose full
access, access to temperature only or no access.
In this last case, the unit's commands are no longer
accessible.
Language
To choose the language.
To register a maximum setpoint temperarure which
cannot be exceeded (
between 22°C and 28°C, set by
default at 28°C)
.
Boost
To set the maximum Boost duration: may be set
from 15 to 120 minutes.
PIN code
To activate the registration of an Expert Menu
personal access code or not.
Once activated, access to the Expert Menu is coded.
You may note your personal code here.
To deactivate it, go back to the Expert Menu,
enter your personal code and go to Settings =>
Restrictions => PIN code.
MENU
Backlight
To choose whether or not to switch on the screen's
backlighting when the appliance is on standby.
Reset
Restore basic factory settings.
To access the appliance's advanced functions, press
and
at the same time for
over 3 seconds.
The EXPERT menu
