Coda, Inc. • 30 Industrial Avenue • Mahwah, NJ 07430 Phone: 201-825-7400 Fax: 201-825-8133
Email:
sales@codamount.com
www.codamount.com
Cold-Mount ® is a registered trademark of Coda Inc.
Cold-Mount® Laminator Operation Manual
January 2006
Heavy Duty Roll Feed Assembly
The Cold-Mount® Laminator should be on a sturdy level table top before attaching the Roll
Feed Brackets.
To attach the Heavy Duty Roll Feed to the Laminator:
Figure 29
Place the brackets against the ends of the
laminator base. The left bracket mounts
against the left side of the machine and the
right bracket mounts against the right side
of the machine. Each bracket has a white
label on it which identifies it as right or left.
Figure 30
The brackets should be positioned so the
labels are against the ends of the laminator
base. There is a fillister head screw on the
label side of each bracket. Position the
bracket so this screw head is butted against
the output side of the machine base. This
will “index” the brackets to the machine to
help assure that the feed bar will be parallel
to the rollers of the machine.
Figure 31
The threaded rod should be positioned so it
goes through the hole drilled in one bracket
base, all the way across the machine under
the machine base and through the hole in the
other bracket. Use a wrench to tighten the nuts
on each end to clamp the brackets against the
base
