3
Hadware Setup
PAN 8
INPUT A
LINK A
INPUT B
LINK B
±1 AMP 1-A
±2 AMP 1-B
SENSOR 1+2
SENSOR 3+4
±1 AMP 2-A
±2 AMP 2-B
OUT 1
OUT 1+2
OUT 2
OUT 3
OUT 4
SENSOR 5+6
SENSOR 7+8
OUT 3+4
L I N E T
AES3 OVER ETHERNET
PRIM
SEC
IN
OUT
DAN
ETHERNET
L I N E T
POWER
ON
OFF
ON
OFF
2
3
1
PUSH
3
2
1
PUSH
3
2
1
2
3
1
2. Module Number assignment
1# Master
1# Slave (follows)
2# Master
2# Slave
3# Master
3# Slave (follows)
(follows)
After selecting the Module Number on the Master unit and entered the command,
the Master Unit starts a device scan...and ends with a message „Device Found 1“
(this is the Slave unit). The Slave unit will automatically follow the Master unit.
Doublecheck the IP adress on the last page on the units displays.
Module No. 1 example- Master: xxx.xxx.xx.01/ Slave: xxx.xxx.xx.02
Module No. 2 example. Master: xxx.xxx.xx.11/ Slave: xxx.xxx.xx.12
Shutdown the complete rack and wait for 5min if the Master/ Slave IP-Address
structure is not in the right order and repeat the module number assignment
