6
FIGURE 8
Wiring directions for AS6FL
(9 wire cable)
The AS6FL 9 wire cable has different wire colors than the standard Arrowstik. The six center lamps
are used as an ArrowStik
®
while the two outboard lamps are connected to a 700 alternating flasher.
The red wire goes to the passenger side outboard lamp and the red/black wire goes to the driver side
outboard lamp. Connect these wires to the 700 flasher according to the flasher wiring instructions below.
Note that terminal D is connected to Ground. Connect the black wire of the cable to the +12 VDC (positive)
side of the battery through a user supplied 20 amp fuse or circuit breaker. If the black wire is terminated at
the controller, use a 12 gauge wire and heavy duty connector to connect the wires. Use the following chart to
correctly wire the remaining wires to the ArrowStik control head.
Standard Arrowstik
Cable
Brown
Orange
Violet
Yellow
Blue
AS6FL 9 Wire
Cable
Yellow/Black
Orange
White
Yellow
Blue
Blue/Black-not used
Operations
The different signaling modes are controlled by the rotary switch on the control head. Changing the rotary
switch controls the signal direction. The ArrowStik face plate is shown in Figure 8.
The light emitting diodes (LED) on the control head indicate the signal pattern of the ArrowStik lighthead. If
the Arrowstik is not functioning correctly, refer to the TROUBLE SHOOTING GUIDE for assistance.
NOTE:
In the Left Arrow mode, the right most lamp and LED will not light.
In the Right Arrow mode, the left most lamp and LED will not light
Summary of Contents for ARROWSTIK AS-10
Page 10: ...FIGURE 10 7 6 1 9 2 3 4 11 12 13 10 14 16 5 15 8 10...
Page 11: ...Notes 11...
