background image

NightProbe and 

Code 3 are registered trademarks of Code 3, Inc. a subsidiary of Public Safety Equipment, Inc.

Revision 2, 03/2006 - Instruction Book Part No. T05083

©2002-6 Code 3, Inc.    Printed in USA

WARRANTY

Code 3, Inc. emergency devices are tested and found to be operational at the time of

manufacture.  Provided they are installed and operated in accordance with manufacturer's
recommendations, Code 3, Inc. guarantees all parts and components except the lamps to a period
of 1 year (unless otherwise expressed) from the date of purchase or delivery, whichever is later.
Units demonstrated to be defective within the warranty period will be repaired or replaced at the
factory service center at no cost.

Use of lamp or other electrical load of a wattage higher than installed or recommended by the

factory, or use of inappropriate or inadequate wiring or circuit protection causes this warranty to
become void.  Failure or destruction of the product resulting from abuse or unusual use and/or
accidents is not covered by this warranty.  Code 3, Inc. shall in no way be liable for other damages
including consequential, indirect or special damages whether loss is due to negligence or breach
of warranty.

CODE 3, INC. MAKES NO OTHER EXPRESS OR IMPLIED WARRANTY INCLUDING,

WITHOUT LIMITATION, WARRANTIES OF FITNESS OR MERCHANTABILITY, WITH
RESPECT TO THIS PRODUCT.

PRODUCT RETURNS

If a product must be returned for repair or replacement*, please contact our factory to

obtain a Return Goods Authorization Number  (RGA number) before you ship the product to
Code 3.  Write the RGA number clearly on the package near the mailing label.  Be sure you use
sufficient packing materials to avoid damage to the product being returned while in transit.

*Code 3, Inc. reserves the right to repair or replace at its discretion.  Code 3, Inc. assumes no responsibility or liability for expenses incurred for

the removal and /or reinstallation of products requiring service and/or repair.; nor for the packaging, handling, and shipping: nor for the handling of
products return to sender after the service has been rendered.

Code 3, Inc.

10986 N. Warson Road

St. Louis, Missouri 63114-2029—USA

www.code3pse.com

NEED HELP?  Call our Technical Assistance Hotline - (314) 996-2800

Summary of Contents for NightProbe

Page 1: ...he holes in the mounting plate with the holes in the lens cover 5 Attach the spotlight with four 6x3 4 screws to the mounting plate 6 Remove the center lens of the lightbar and keep the four lens clips for reuse 7 Route the cables through the existing hole in the bottom of the lightbar insure that there is adequate length to reach the area in which the controller is to be mounted 8 Install the spo...

Page 2: ...01 4 Fastener 14x3 4 with washer seal T05070 06 5 Fastener 6x3 4 T01031 04 6 Fastener 8x 270 T01215 08 7 Spotlight mounting bracket Code 360 Excalibur S50795 01 MX S50593 01 8 Spacer Spotlight in lightbar S96254 03 9 Mounting Plate S50796 01 Shown separated for clarity actual assembly is sealed together with caulk adhesive Figure 2 ...

Page 3: ...ser should check all applicable city state and federal laws and regulations Public Safety Equipment Inc assumes no liability for any loss resulting from the use of this warning device Proper installation is vital to the performance of this warning device and the safe operation of the emergency vehicle It is important to recognize that the operator of the emergency vehicle is under psychological an...

Page 4: ...d by this warranty Code 3 Inc shall in no way be liable for other damages including consequential indirect or special damages whether loss is due to negligence or breach of warranty CODE 3 INC MAKES NO OTHER EXPRESS OR IMPLIED WARRANTY INCLUDING WITHOUT LIMITATION WARRANTIES OF FITNESS OR MERCHANTABILITY WITH RESPECT TO THIS PRODUCT PRODUCT RETURNS If a product must be returned for repair or repla...

Reviews: