920-0451-00 Rev. A
Page 1 of 6
Operation Instructions
SmartPro Configuration Interface
Introduction:
The SmartPro Configuration Interface is a handheld flash
pattern programming device for use with Code 3 Ligthbars and
Microsoft PC based systems.
Contents:
Software Installation.........................................................01
Configuration....................................................................02
Set-Up Configuration...............................................02
Saving a Configuration File.....................................02
Loading a Configuration File...................................02
Writing Configuration to the Handheld Unit.............02
Reading Configuration to the Handheld Unit...........02
Programming...................................................................03
Programming a Lightbar..........................................03
Reading a Lightbar..................................................03
Troubleshooting...............................................................03
Glossary...........................................................................04
Notes...............................................................................05
Warranty..........................................................................06
IMPORTANT! Read all instructions before installing and using. Installer: This manual must be delivered to the end user.
1. Insert flash drive into the computer’s USB port.
2. After locating the flash drive on your computer screen, click on the SmartPro_Configuration_Interface-x.x.x.x (latest version)
executable (.exe) file.
3. After the program opens, follow the prompts on the screen to complete the installation.
Smart Pro Software Installation
Smart Pro
Flash
Drive
USB Cord
1000+ Series
Cable
800-951
Series
Cable
Install on Windows version 7, or higher.
TM
