10
2. Advanced Harness (A)
2/A Factory Alarm Arm Output (20 AWG-) (BLACK/GREEN)
Connect the 2/A wire to the vehicle anti-theft arm wire (if
equipped).
Verification:
This wire will register ground when the driver’s door
is locked with the key. Refer to
Vehicle Wire Color and Location
Chart
for specific color and polarity information.
2/A Retained Accessory Output (20 AWG-) ( BLACK/GREEN)
This wire also has the ability
to go active after the ignition
has been turned off for 1
minute or until the door has
opened. This is a selectable
option please refer to option
programming on page 16.
Use a SPDT relay (not supplied) and connect the 2/A wire as
shown (Diagram 11), this will keep the accessories active
(i.e.Radio, Windows ,Etc)
4/A
Factory Alarm Disarm (20 AWG-) (LT.GREEN/BLACK)
Connect the 4/A wire to the vehicle anti-theft disarm wire (if equipped).
Verification:
This wire will register ground when the driver’s door
is unlocked with the key. Refer to
Vehicle Wire Color and Location
Chart
for specific wire color and polarity information.
8/A
Trunk Pin Input (20 AWG-) (BLUE)
Connect the 8/A wire to the vehicle’s wire that registers ground
when the trunk is opened.
9/A
Trunk Switch 87A (20 AWG) (TAN/RED)
This wire is the normally closed pin (87A) for the internal trunk
release relay. If the vehicle has a 5-wire type trunk release it will be
necessary to cut that wire and connect 9/A to the switch side of that
wire.
Note:
See 13/B description (Basic Harness).
10/A Aux 1 500mA (20 AWG -) (RED/WHITE)
This wire provides a 500mA negative output capable of driving
relays. For control of optional accessories (i.e.: power window/
sunroof, etc.
2/A BLACK/
GREEN
+12v fused
Diagram 11
86
87
85
30
87a
To vehicles
Accessory wire
CA-130 install rev 7-04.pmd
7/28/2004, 3:32 PM
10
