3
ca2051 rev B. 2011 Audiovox Electronics Corporation. All rights reserved.
Locking the Vehicle
To lock the vehicle, exit the vehicle, close all doors, then press the button. The
parking lights will flash 2 times, indicating the system has locked the doors and
activated the starter interrupt feature (if equipped and connected). The LED
status indicator will blink steadily, once per second.
NOTE: The system is equipped with a feature called Silent Choice. If enabled, the
system requires a second press of the button to activate an audible locking
response from the vehicle.
Using Your Remote Control
Two Stage Door Unlock (Optional)
If this feature is enabled on your system, pressing the button one time will
unlock only the driver’s door. Press again within three seconds to unlock the
remaining doors.
Eliminating Lock / Unlock Notification Chirps
System lock and unlock notification chirps can be toggled ON or OFF without
entering the programming feature banks.
1.
Turn the ignition ON then OFF.
2.
Press and release the valet/programming button 3 times. The system
will respond with 1 chirp for ON or 2 chirps for OFF.
Valet Mode
When valet mode is activated the status LED will light solid, and the optional
starter interrupt feature will be disabled. To enter or exit valet mode simply follow
the 4 steps outlined below:
1.
Turn the vehicle’s ignition ON.
2.
Push and hold the programming/valet button.
3.
The LED will turn on solid when valet mode is active
4.
Release the programming/valet button.
Unlocking the Vehicle
To unlock the vehicle press the button. The parking lights will flash 1 time,
indicating the system has unlocked the doors and disabled the starter interrupt
feature (if equipped and connected).
NOTE: The system is equipped with a feature called Silent Choice. If enabled, the
system requires a second press of the button to activate an audible unlocking
response from the vehicle. If your system is set up for 2 step unlock, a third
press of unlock will activate the audible response.
