10
ca4552. 2011 Audiovox Electronics Corporation. All rights reserved.
4
BLACK/YELLOW
PULSE DURING CRANK ( - )
Locate the vehicle’s second starter (crank) wire at the ignition switch. (if equipped)
Verification: This wire registers voltage only in the start (crank) position of
the ignition switch.
Connect the BLACK/YELLOW wire as shown in the diagram below. Use an SPDT
relay (not supplied).
This output is configurable in option programming.
F us ed +12 Volt
B attery S ource
30
87
87a
86
85
B L AC K /Y E L L OW P uls e
During C rank W ire
To Vehicle's 2nd
S tarter W ire
J ump To P UR P L E
S tarter O utput
W ire F rom T he
C ontrol Module
2 Pin Lock Output Harness
1
BLUE
UNLOCK ( - )
The door unlock output wire provides an output only while the remote start feature
is active.
3
GREEN/WHITE
PULSE AFTER SHUTDOWN ( - )
This wire will supply a ( - ) 500mA pulse after the remote start shuts down. This
is typically used to re-lock the vehicle’s doors if they unlock upon remote start
shutdown. It can also be used to pulse a door pin-switch wire to prevent the
vehicle’s accessories from remaining on after remote start shutdown.
This output is configurable in option programming.
