Code Alarm CA 5051, Installation Manual

15

2010 Audiovox Electronics Corporation. All rights reserved.

Manual Feature Programming - Feature Bank 2 - 4

1.

Turn the ignition ON.

2.

Press and hold the valet/override button.

3.

Within 10 seconds the system will chirp (3) three times.

4.

Use the valet/override button to advance through each option bank. For
feature programming advance to Feature Bank 2, 3  or 4, which is  (4) four,
(5) five, and (6) six chirps.

5.

Use the transmitter   button to scroll through the selections in each feature
bank, the system will chirp to match the feature number.

6.

Press the transmitter     button to change the desired feature. The LED will
flash indicating the changed feature.

Defaulting All Features: Pressing the   button anytime while in any of the
feature banks will default all features and return you to feature bank 2 - 4 chirps.

NOTE: The system will remain in feature programming mode as long as the
ignition is on, there is no time limit. To exit programming turn the IGNITION OFF.

Set Up & Programming

Transmitter Programming - Feature Bank 1

1.

Turn the ignition ON.

2.

Press and hold the valet/override button.

3.

Within 10 seconds  the system will chirp (3) three times.

4.

Press 1 button of each transmitter you wish to program.

5.

The system will respond with 1 chirp for each accepted transmitter.

6.

Pressing the override button at anytime during programming will advance to
the next bank.

NOTE: The system will exit transmitter programming after 15 seconds of inactivity.

NOTE: This system has 1 button programming which programs all channels of the
system.

NOTE: The system will hold up to 4 transmitters in memory, programming a 5th
transmitter will erase the oldest transmitter in memory.

NOTE: This system has PTN - Programmed Transmitter Notification. Each time the
ignition is turned ON, the LED will flash the number of transmitters programmed to
the system.