128-6530
5 of 10
Page 5
MANUALLY OVERRIDING YOUR SYSTEM:
USING THE VALET SWITCH/ MANUAL OVERRIDE
Your system can be disarmed without the use of the keychain transmitter. This
is necessary, since you will need the ability to operate your vehicle if the
transmitter is lost or its battery fails. To by-pass the alarm system;
1. Open the vehicle door. The alarm will sound.
2. Turn the ignition key to the ON position.
3. Within 5 seconds, press and release the valet pushbutton switch.
The alarm system will stop sounding and enter the (by-passed) mode. You
can now start and operate the vehicle normally.
Typically this override mode is used only if the transmitter has become
inoperative.
ELIMINATING THE NORMAL ARM/DISARM CHIRPS
You can selectively eliminate the normal arm & disarm chirps by holding the
transmitter button slightly longer when arming or disarming. This will prevent
the siren chirps for one arm or disarm cycle. If you find this inconvenient and
wish to eliminate these chirps permanently, please check with your
installation center.
REMOTE PANIC OPERATION:
The LOCK button on your keychain transmitter also functions as a panic
switch for use in emergency situations. To use remote panic,
1.
Press and hold the LOCK button on the keychain transmitter for 3 or more
seconds. The alarm will immediately sound.
2.
To stop the alarm, press and hold the LOCK button on the transmitter
again for 3 seconds. If the button is not pressed, the alarm will
automatically stop after 30 seconds.
NOTE: While in the Panic mode, pressing and releasing the Lock, or the
Unlock buttons will, if the option is installed, lock and unlock the doors
respectively. While in the panic mode, anytime the unlock button is pressed,
