Code Alarm PC 7500, Owner'S Manual

6

Using Valet Mode

If the Passive Arming feature is enabled on your system, Valet mode
temporarily prevents the alarm system from arming automatically.
This is useful when fueling or servicing your vehicle.

To enter Valet Mode:
With the vehicle ignition on, press the ARM button. The red dashboard
warning light (status indicator) will turn on for one second, then turn
off. This indicates that the system is in Valet mode. Once the ignition is
turned off, the status indicator will emit a quick double-flash pattern.

Note: In Valet mode, all keyless entry, convenience and remote start
features operate normally.

To exit Valet Mode:
With the vehicle ignition on, press the DISARM button. The red
dashboard warning light (status indicator) will turn on for one second,
then turn off. This indicates that the system has exited Valet mode.

Hint: To prevent your security system from automatically arming while
unloading or refueling your vehicle, without placing the system in
Valet mode, simply press the disarm button on your remote control
transmitter after turning the ignition key off. Doing so places your
system into a temporary or onetime Valet mode.  Next time you exit
your vehicle the system will arm in the normal manner.

Using Your Remote Starter

Starting Your Vehicle

The remote start function is activated by pressing the ARM button,
then pressing the START button on the remote control within 2
seconds. The system will check the vehicle to ensure that it is safe to
start, and if all safety parameters are correct, the engine will start
within 5 seconds (diesel engines will take longer.) Press and hold
START again to turn off the vehicle.

If your vehicle stalls or does not start...
If the vehicle stalls or does not start, the Power Code PC 7500

TM

 will

pause 5 seconds, then try 3 more times to start the vehicle (a total of
four attempts). The system pauses 5 seconds between each start
attempt. If the vehicle does not start after the fourth attempt, the Power
Code PC 7500

TM

 will abort the start process.

Your vehicle can be started by remote control whether the alarm is
armed or disarmed. When the alarm is armed, the impact sensor turns
off when the vehicle is started to prevent the engine vibration from
setting off the alarm.

Using Your  Remote Transmitter 

(cont.)