6
Automatic Convenience Options
The Power Code PC 6100
TM
performs a variety of automatic functions
to enhance security and comfort. Some of these features are
programmable at the time of installation. Please see your installer
for further details.
Illuminated Entry
When the alarm system is disarmed, the vehicle courtesy lights will turn
on for 1 minute, or until the vehicle is started or the system is re-armed.
Illuminated Exit
When removing the key from the ignition, the vehicle courtesy lights
will turn on for 1 minute, or until the Power Code PC 6100
TM
is armed.
Automatic Arming
The Power Code PC 6100
TM
Starter Interrupt will arm automatically
one minute after the key is removed from the ignition (if enabled).
This feature can be temporarily disabled by placing the system
into Valet mode.
Ignition Lock
If all doors are closed and the vehicle is started with the key, the doors
will automatically lock.
Ignition Unlock
When removing the key from the ignition, the doors will automatically
unlock.
Changing the Remote Control Battery
The two 3-v lithium batteries (CR2016) supplied in your remote
control should last approximately one year, depending on usage.
When the battery begins to weaken, you will notice a decrease in
range, or the distance from your vehicle that your remote transmitter
will operate. Follow the instructions below to change the remote
transmitter battery.
1.
Insert the edge of a coin into the slot at the top of the remote
control. Twist the coin to pry the remote control halves apart.
2.
Remove the old batteries and replace with new ones.
Be sure to observe the (+) and (-) signs in the battery
compartment.
3.
Carefully snap the case halves back together, then test the
remote control.
Summary of Contents for PowerCode PC 6100
Page 11: ...11 Notes ...
Page 12: ...12 ...
