TEST MODE
In this test mode, this system can test the all of the trigger input. The installer can save time to test the
sensitivity of the 2-stage shock sensor and optional sensor and without using the traditional
rming/disarming procedures to test the sensors.
a
1. Press the
button
to disarm the system,
within 10 seconds
2.
Spin up the switch to
the page 5
3. Select 1 / 2
4. Press button
2
to test the Two Stage Shock Sensor
:
Two chirps to indicate your are in the two-stage
shock sensor test mode.
1. Activate the warn-away (first stage of the shock sensor); system will emit a short chirp.
2. Activate the full alarm (second stage of the shock sensor); system will emit a long chirp.
3. Continue to test the shock sensor until reach the proper sensitivity.
5. Press button
3
to test the two-stage Optional Sensor
:
Three chirps to indicate your are in the two-stage
optional sensor test mode.
1. Activate the warn-away (first stage of the shock sensor); system will emit a short chirp.
2. Activate the full alarm (second stage of the shock sensor); system will emit a long chirp.
3. Continue to test the optional sensor until reach the proper sensitivity.
Exit:
While in test mode, turns the ignition
On
and
OFF
.
20