If the power cord needs to be replaced, replace it only with another Codonics power cord manufactured
specifically for your power configuration.
If the device is smoking or making unusual sounds, power off and unplug the device immediately.
Do not insert foreign objects of any kind into the device; doing so can constitute a safety hazard and cause
extensive damage.
Do not place any liquid containers on the device. If, for some reason, liquid seeps into the device, power off the
device and unplug the power cord from the source outlet. If used without corrective measures, the device may
be damaged.
Do not use the device near flammable gases.
Location Precautions
The device’s operating ambient temperature range is 15–
30ºC (59
–
86ºF), with a relative humidity of 20%
–
80%.
If the device is moved quickly from an extremely cold place to a warmer one, condensation is likely to form. Do
not use the device if condensation has formed. Wait until the condensation has evaporated. You can speed up
the evaporation time by moving the device to a drier location.
Ventilation slots and holes are provided on the sides and rear of the device. Place the device on a level, stable
surface and locate it at least 10 cm (4 in.) from walls to ensure proper ventilation.
WARNING:
Adequate ventilation is required for proper operation of the device.
Do not place device in a high humidity or high dust area. Airborne dirt particles can cause interference with the
operation of the device. Avoid placing the device in areas where ventilation ducts, open doors, or frequent
passers-by might expose the device and media to high levels of debris.
Do not locate the device in hot-springs areas where hydrogen sulfide and acidic ions are likely to be generated.
Do not locate the device where there are oily fumes and vapors.
Do not locate the device in direct sunlight.
Do not locate device near sources of high RF energy.
Do not locate the device where it might be subject to jarring or vibrations, such as a table or desk in a high-
traffic area. Jarring and vibrations can affect the recording and labeling of discs.
Cleaning Precautions
Many plastic components are used in the device’s construction. Coat flecking and deformation is likely to occur
if the device is wiped with chemical dusters, benzene, thinners, insecticides, or other solvents. Rubber and PVC
