Coemar CF 1200 Spot, Manual

17. Electronic alignment

The display panel at the rear of the 

CF 1200 Spot 

allows for the electronic 

of motors

alignment of the projector’s motors. This procedure is performed by 

coemar

at the

factory. It may be useful to perform this procedure in the case of internal compo-
nents being replaced.
Altering the 

coemar

factory settings may radically alter the functioning of the

projector; carefully read all of the following prior to attempting any changes.

Electronic calibration

Important Note: 

The electronic calibration procedure is only possible if the fixture

is receiving 

DMX 512

signal.

1) Press the 

menu

button

2) Press the 

+

or 

-

buttons until 

rESE

(for reset) is displayed.

3) Press and hold the 

enter 

button to confirm your selection. Keeping this depres-

sed, simultaneously press and hold the 

menu 

button, keeping both depressed

for at least 

30 seconds

. The motors of the fixture will perform a reset, and the

display will be as in the following diagram, confirming that you have entered into
electronic calibration mode.

PnAl

1) Press the 

+

or 

-

buttons until 

PnAL

(for pan alignment, movement of the base

motor of the unit) is displayed.

2) Press the 

enter

button to confirm your selection. The display will show a numeri-

cal value which corresponds with the factory setting.

3) Press the 

+

or 

-

buttons until the displayed number corresponds with the correct

alignment of the unit (note that with each press of 

+

or 

- 

the motor will move).

4) Press the 

enter

button to confirm your selection.

tLAL

1) Press the 

+

or 

-

buttons until 

tLAL

(for tilt alignment, movement of the yoke) is

displayed.

2) Press the 

enter

button to confirm your selection. The display will show a numeri-

cal value which corresponds with the factory setting.

3) Press the 

+

or 

-

buttons until the displayed number corresponds with the correct ali-

gnment of the yoke (note that with each press of 

+

or 

- 

the yoke motor will move).

4) Press the 

enter

button to confirm your selection.

SHAL

1) Press the 

+

or 

-

buttons until 

SHAL

(for shutter/black-out alignment) is displayed.

function display

menu

+

-

enter

function display

menu

+

-

enter

function display

menu

+

-

enter

function display

menu

+

-

enter

function display

menu

+

-

enter

function display

menu

+

-

enter

function display

menu

+

-

enter