7.5. Rapid scrolling
Via the
Panorama Power MK2
display it is possible to rapidly scroll through the various numbers displayed in the menu in the follo-
wing manner:
1.
Pressing the
+
or
-
buttons will cause the number to scroll more quickly.
2.
Pressing and holding the
+
button and then the
-
button will cause the numbers to jump to the highest value.
3.
Pressing and holding the
-
button and then the
+
button will cause the numbers to jump to the lowest value.
7.6. Connecting the DR1
All the functions available via the display menu are also available via the
DR1
(cod.
9703
).
The
DR1
is a remote device designed for technical users who need to perform tasks on the projectors whilst they may be located in
inaccessible positions. It acts as a remote control.
The
DR1
eliminates the need for climbing up truss structures to gain direct physical access to the projector to alter such parameters as
DMX address, reading outputs such as lamp life, setting master/slave configurations as well as all other functions available via the digi-
tal display unit on the projector.
In order to utilise the
DR1
remote device, you must first activate the identifying number
ID
of the projector, which must be unique in
the particular DMX universe in which it is currently installed.
The method for setting an identification number
ID
is shown below.
For further information, consult the
DR1 instruction manual.
☞
menu
MODE
MEAS
AOO1
FUNC
☞
+
o
--
☞
+
o
--
☞
enter
ID
ID number setting
To set the unit’s ID number from 1 to 250
1--250
numeric value
☞
enter
☞
+
o
--
☞
enter
ATTENTION!!
• If you set a projectors identification number to “0” it will not be able to communicate with the DR1
.
• Never assign the same ID to two or more projectors. This may jeapordise the functioning of the entire system.
(The DR1 will show an error message).
20
English
