This function allows for control via an optional infrared controller and receiver (infrared receiver cod.
CO9163
, controller cod.
FO9281
).
Via this function, it is possible to select the operating mode (
STAND ALONE
or
MASTER/SLAVE
). The use of this function disables the
use of DMX signal.
10.1. IR MASTER/SLAVE mode
In MASTER/SLAVE mode it is possible to control a fixture set as MASTER, and other
Par Lite Led IP
configured as SLAVES. The follow-
ing diagram outlines the necessary settings for this configuration.
To configure a
Par Lite Led IP
as
MASTER
set the IR
and Auto
dip-switches to
ON.
To configure a
Par Lite Led IP
as a
SLAVE
set the
IR
dip-switch to
ON
and set to
ON
the
dip-switch corresponding the the desired group. It is possible to subdivide the units set as
SLAVE into four groups which can be controlled independently. The following diagram out-
lines the necessary settings for this configuration.
Group
1
- Dip-switch
1
Group
2
- Dip-switch
2
Group
3
- Dip-switch
4
Group
4
- Dip-switch
8
To configure a
Par Lite Led IP
as
SLAVE group 3
set the
IR
dip-switch to
ON.
Select the
group by setting the
ON
dip-switch to
4
.
ATTENTION!!
To control a Panorama Led RGB SLAVE unit, the controller should be pointed
at its corresponding group’s MASTER fixture.
Par Lite Led IP
set as
SLAVE group 3
ON
256
auto
test
light on
DR1
1
2
4
8 16 32 64 128
IR
SLAVE IR
ATTENTION!!
The SLAVE unis of group 1 behave as the MASTER units.
Par Lite Led IP
set as
SLAVE group 2
ON
256
auto
test
light on
DR1
1
2
4
8 16 32 64 128
IR
SLAVE IR
Par Lite Led IP
set as
MASTER IR
ON
256
auto
test
light on
DR1
1
2
4
8 16 32 64 128
IR
MASTER IR
out
Ad altri
Par Lite Led SLAVE
Connect to other
Par Lite Led SLAVE
out
in
out
in
10. IR function
16
English
