10.2. IR STAND ALONE mode
In
STAND ALONE
mode the projector operates independently of any DMX control signal. All inputs are via the remote control.
To set the
Par Lite Led IP
to
STAND ALONE
mode, set the
IR
dip-switch
to ON.
This function allows for the transmission of bidirectional data with the
DR1
(cod.
CO9703
). Via the
DR1
(display remote) it is possible
to remotely access, view and alter all the fixture’s parameters and settings.
The
DR1
remote display unit allows the user to:
Monitor:
1) the current Software Version loaded
2) temperature
3) led operating life
4) projector operating life
5) presence and characteristics of incoming DMX 512
6) error messages
7) ID code
8) alarms
Edit and set:
1) DMX address
2) force leds on
3) function mode
To initiate communications with the
Par Lite Led IP
the
DR1
must be installed into the DMX signal chain between the fixture and
the controller following the instructions located internally on the unit.
The
DR1
dip-switch must be set to the
ON position
; from this point on, dip-switches 1 to 128 take on the task of assigning an iden-
tifying value (ID) to the fixture. They no longer set the fixture’s DMX address, which is done by the
DR1
. The maximum number of
unique IDs available in the
DR1
system is 250; dip-switch 256 has no functionality.
An example of a possible configuration is shown below:
Par Lite Led IP
set to ID 13 and
DR1 active
configured by setting dip-switch
DR1
to
ON
and dip-switches
1, 4
and
8
to
ON
ON
256
auto
test
light on
DR1
1
2
4
8 16 32 64 128
IR
11. DR1 function
Par Lite Led IP
set to
STAND ALONE IR
ON
256
auto
test
light on
DR1
1
2
4
8 16 32 64 128
IR
STAND ALONE IR
17
English
