15
7
. Turning the projector on
!The factory setting at the first start up will be in “
SUNRISE
MODE
” at 2000Hz.
After having followed the preceding steps described, proceed with the power supply and turn on the projector
connecting it to the mains power.
8.2
RDM Chart
PARAMETER
DESCRIPTION
DMX ADDRESS
Set Dmx Address: (1-512)
CURVE
Set Dimming Curve: Linear, Logarithmic, Exponential, Halogen
FREQUENCY
Set Pwm Frequency: 600Hz-1500Hz-2000Hz-5000Hz-20.000Hz
LOCK PIN
Set Lock Pin
LOCK STATE
Set Screen Lock
FACTORY DEFAULT Factory Reset
PERSONALITY
Set Personality: 5Ch, 2Ch, 4Ch, Sunrise Mode
SENSOR
Visualize Sensor
LED HOURS
Visualize Led Life Hours
DEVICE HOURS
Visualize Device Life Hours
8
. Setup via RDM
8.1
Quick guide to menu
The
SunLite LED Series
required RDM (Remote Device Management) to set up fixtures. Using an RDM-
compliant DMX controller, you can communicate with all the fixtures on a data link without needing to connect
to each fixture individually. RDM lets you set the DMX addresses of all the fixtures on the link, carry out fixture
configuration and retrieve fixture data including details of any error that has been logged.
If two or more identical fixtures are set up with the same DMX address and in the same DMX mode, they will
receive the same instructions and behave identically. Setting up identical fixtures with the same address is a
good tool for troubleshooting unexpected behavior and an easy way to achieve synchronized action.
Setting DMX addresses via RDM involves running a scan to identify the fixtures that are present on the data
link and then allocating addresses either automatically or manually.
To use RDM:
1. Obtain an RDM-compatible controller such as the RDM UPGRADE INTERFACE B
(cod. AC10011A001 ) application running on a Windows PC.
2. Use a USB cable to connect the PC to a USB/DMX interface box
3. Connect the interface box to the data link.
4. Power the fixture on and carry out an RDM discovery / scan in your RDM-compatible controller.
5. You can then configure or retrieve data from the fixtures on the data link.
