7
Prevention from electric shock:
1.
Presence of high voltage inside of the fixture. Insulate the projector from mains supply
before opening or performing any function which involves touching the inside of the
fixture, including lamp replacement.
2.
For the connection to the mains, adhere strictly to the guidelines outlined in this manual.
3.
The level of technology of
SunLite LED
requires the use of specialised personnel for all
service applications; refer all work to your authorised
Coemar
service centre.
4.
A good earth connection is essential for the proper functioning of the projector.
5.
Never connect the fixture if there is no earth connection.
6.
Mains cables must not come into contact with other cables.
7.
Do not operate the projector with wet hands or in an area where water is present.
8.
The fixture must never be located in an exposed position, or in areas of extreme humidity.
9.
Do not immerse the fixture in water or liquid.
10.
Do not apply power if the device or mains cable is in any way damaged.
Safety:
1.
The projector must always be installed with bolts, clamps, or other fixing devices which are
suitably rated to support the weight of the projector.
2.
Always use a secondary safety fixing device with chain or steel wire of a suitable rating to
sustain the weight of the unit in case of failure of the principal fixing point.
3.
Devices and accessories must be secured against fall when mounted above floor level.
Always observe common and local safety regulations.
4.
The stirrup must be mounted hanging or standing vertically. Lateral load can cause defor-
mation or breaking of the spigot and the stirrup.
5.
The external surfaces of the unit, at various points, may reach 80°C. Never handle the
unit until at least 10 minutes have elapsed since the LED was turned off.
6.
Never install the fixture in an enclosed area lacking sufficient air flow; the room tempera-
ture must not exceed 40°C.
7.
The projector contains electronic and electrical components which must under no cir-
cumstances be in contact with water, oil or any other liquid. Failure to do so will compro-
mise the proper functioning of the projector.
8.
Do not operate the fixture with missing or damaged covers, shields or any optical com-
ponent.
9.
Do not attempt to bypass thermostatic switches or fuses.
10.
For elevated installations, secure the fixture with suitable safety cables, and always comply
with relevant load dimensioning, safety standards, and requirements.
11.
Caution! High intensity light emission. Risk of eye injury.
12.
Take precautions when working at height to prevent injury due to falls.
13.
Do not look directly at the light source from close range.
14.
Provide well-lit conditions to reduce the pupil diameter of anyone working on or
near the fixture.
15.
Wear protective glasses and other PPE (personal protective equipment) when
working on or near the fixture.
16.
Ensure that persons are not looking directly into the front of the fixture when the
product lights up suddenly. This can happen when power is applied, when the prod-
uct receives a DMX signal, or when certain control menu items are selected.
