14
ENGLISH
16.
Keep all nuts, bolts and screws tight and ensure equipment is in safe working condition.
17.
Do not put hands near or under moving parts.
18.
Air Hose
It is not recommended to install a quick coupler between the die grinder and leader (whip)
hose. Using fittings or air hoses which are too small can create a pressure drop and reduce
the power of the tool. For 3.175mm(1/8”),6.35mm(1/4”) and 30mm PAD die grinder, using
9.525 mm (3/8”) I.D. fittings with 6.35 mm (I/4”) NPT threads are recommended.
Most compressors are shipped with a short, 6.35 mm ( 1/4”) I.D. hose. For proper
performance and more convenience, use a 9.525 mm (3/8”) I.D. hose. Hoses longer than
15.24 m (50 feet) should have a 12.7 mm (I/2”) I.D.
Never carry a tool by the hose or pull the hose to move the tool or a compressor. Keep hoses
away from heat, oil and sharp edges. Replace any hose that is damaged, weak or worn.
19.
Storage.
The die grinder must be lubricated before storing. Follow the air motor lubrication
instructions with an exception to step 4. Only run the die grinder for 2 to 3 seconds instead of 20 to
30 seconds because more oil needs to remain in the die grinder when storing.
2. Particular Safety Instruction
1. Information of Noise Level.
(1) The noise level at the operator’s position is about:
Sound Pressure Level : 90~109 dB(A).
Sound Power Level: 102~109 dB(A).
(2) Reference standard : ISO 3746.
(3) Always wear ear protectors during operation
2. Information of Vibration Level
(1)The vibration level at the handle is about : 7.802~10.580 m/s2.
(2)Reference standard : EN 28662-1.
3. Information of Temperatures
(1)The temperatures at the handle (8 hours/Operation) is 30 0C .
4. Safety Information
The rated no-load speed is 15000~28000 rpm.
