17
ENGLISH
Disconnect the die grinder from the air supply before lubricating.
3.1. Disconnect the die grinder from the air supply.
3.2. Turn the die grinder upside down.
3.3. Simultaneously (at the same time), pull the trigger and pour a teaspoon of oil in the air inlet.
Then, push the forward and reverse button in both directions.
After an air tool has been lubricated, oil will discharge through the exhaust port during the
first few seconds of operation. Thus, the exhaust port must be covered with a towel before
applying air pressure. Failure to cover the exhaust port can result in serious injury.
4.
Connect the die grinder to the air supply and cover the exhaust port with a towel.
Run the die grinder and oil will discharge from the exhaust port when air pressure is applied.
5.
Grinding mechanism lubrication
The die grinder should be lubricated monthly.
Check the speed and make a simple check of the vibration level after each service.
Take special care when assembling the speed governor or any other protective device.
Check the speed regularly.
