20
ENGLISH
General Troubleshooting Guide
Moisture blowing
out of tool.
1. Water in tank.
2. Water in the air lines/hoses.
1. Drain tank. (See air compressor manual).
Oil tool and run until no water is evident.
Oil tool again and run 1-2 seconds.
2-1. Install a water separator/filter.
Note: Separators only work properly when the air
passing through the separator is cool. Locate the
separator/filter as far as possible from
the compressor.
2-2. Install an air dryer.
Ratchet slowly or
Does not ratchet.
1. Lack of lubrication.
2. Tool regulator set in wrong
position.
3. In-line regulator or compresor
regulator set too low.
1. Lubricate the air motor and the impact
mechanism.(See lubrication section of
this manual)
2. Adjust the regulator setting of the tool.
3. Adjust regulators in the air system.
Ratchet rapidly
But does not
remove
bolts.
1. Worn ratchet mechanism.
1-1. Replace ratchet mechanism.
1-2. Return ratchet wrench to your supplier for repair.
Does not ratchet.
1. Worn ratchet mechanism.
1-1. Replace ratchet mechanism.
1-2. Return ratchet wrench to your supplier for repair.
