54
CHAPTER 3
®
10.3.5 Baud Rate
In this menu item the start rate for the data recording by infrared in the Aeterna Coin
Mechanism is set. The default data is 2400 Baud Rate, which represents the value specified
by the EVA-DTS protocol. The submenu foresees the following options:
•
2400 (default);
•
4800;
•
9600;
•
19200;
•
38400;
•
57600;
•
115200.
Note: the start rate has to be selected according to the start rate set in the palmtop PC
which is used for the data recording.
10.3.7 Printer Recording
This function permits to choose the type of recording to be carried out by means of the prin-
ter. Further details about the data recording by printer are described at the end of chapter 3
(see para. 3.3.5. “Recording by means of printer”).
•
Partial (default);
•
Cumulative.
Partial
With this type of recording the printer will read the totals stored inside the Partial Totals
menu item, starting from the last data recording.
Cumulative
With this type of recording the printer will read the cumulative totals. They are stored
inside the Cumulated Totals menu and are not deleted after the data recording, but only
when the system is initialized again (see para. “14 Default”). The setting of this mode
always foresees the delete of the partial totals after the data recording.
10.12 Audit Executive
This menu item, available only for the Executive protocol, is used in case the data recording - in
addition to the System - is extended to the vending machine too. It foresees that the Coin
Mechanism sends the accounting data, which are foreseen by the Executive protocol, to the
vending machine. Options available:
•
Active;
•
Not Active (default).
11 Key Setup
[Operator (
)]
In this menu are set the parameters for key management; it foresees the following items:
•
11.1 Machine Code;
•
11.6 Credit Limit;
•
11.19 Recharge Key.
11.1 Machine Code
It is a code, consisting of 8 digits, which identifies the single Coin Mechanism. This code is very
useful in accounting data recording to identify the device. As a default the data set is 00000000.
11.6 Credit Limit
The menu foresees the following item:
11.6.1 Limit Value
It is the credit limit beyond which the key is not accepted by the System. If the code is zero
the function is not active. The setting range is included between 0.00 and 64999.00. As a
default the data set is 30.00.
