313196
LAMP 10LED + SOLAR PANEL + REMOTE CONTROL
Réf 313196
Instruction Manual
A: Main Unit B: Solar Panel C: support.
Features:
Main unit: 3 rechargeable AA batteries supplied LR06
Remote: 2 AAA LR03 batteries not included. Maximum range: 15m.
Information: Before installing a solar lamp to please the rain CPU but be aware that the solar panel is waterproof. Choose
the best possible location for your panel, put it in a place where sun exposure is greatest during the day.
Remote Control:
It is advisable to use saline or alkaline batteries, do not mix batteries with alkaline saline.
Please store the remote control to protect from moisture.
When you turn on your lights, point the remote at the main unit. The sensor is located under the ramp light 10LED.
Start:
After installing your solar lamp, please ensure that you put in the solar charger to sunlight for at least 3 days before turning
on the light so that it can operate on a maximum load. Therefore if you want to use your lamp, set the switch to ON.
ON --
Position for normal operation of the aircraft.
OFF ---
Position for transport or periods of prolonged use.
Position for an initial period of 3 days before the final adjustment and the first use. (Although the device can handle, it does
not work in this mode)
Turn the camera on now OFF (STOP). In this position, the solar cell will charge the battery without activating the unit. Leave
the switch in this position for three sunny days so that the batteries are fully charged before use under normal conditions.
Replacement batteries:
Set the switch to "OFF", press the button is open the battery compartment under the product and remove the batteries and
replace them with 600mAh rechargeable AA batteries. Replace the battery compartment cover. Hold the switch in OFF
position for 2 days to get fully charged batteries
Warning:
Respect the polarity at the position of those above.
Do not put any salt or alkaline batteries in the main unit, put only rechargeable AA batteries LR06.
Do not mix batteries and batteries.
STORAGE:
If you want to store your product inside for more than two or three days, follow these steps to ensure that the battery is
damaged:
Set the switch OFF
GB
A
B
C
