Replace a Ring Light without a Shroud
If the pre-installed ring light on your vision system does not have a shroud, and you need to replace it with another ring
light that also does not have a shroud, please complete the following steps.
1. Verify that the 24VDC power supply is unplugged and not receiving power.
2. Remove the lens cover, if present.
3. Loosen the ring light.
a. Using a screwdriver, loosen the two screws on the ring light.
Note
: Do not attempt to remove the screws from the ring light; the screws are held in place with
washers on the back of the ring light.
b. Pins on the back of the ring light are connected to the vision system. Using small tweezers, grab the notch
on the ring light that is closest to the pins, and gently pull up to disengage the pins from the vision system.
4. Remove the ring light from the vision system.
18
Replace the Ring Light
