Cohu Electronics
5930 Series Thermal Camera User's Manual
Cohu Electronics
P
AGE
9
OF
17
3912 Calle Fortunada
San Diego, CA 92123-1827
Phone: 858-277-6700
Fax: 858-277-0221
2.3
Electrostatic Discharge (ESD) Precautions.
The installation procedures in this user's manual do not require entry into the Enclosure of the
Camera. However in the event that the camera needs to be opened as directed by Cohu
Electronics , the following ESD precautions should be followed:
Use a conductive pad on whatever work space used.
Connect the conductive pad to earth ground through a 1M
Ω
resistor.
Use a wrist strap connected to earth ground through a 1M
Ω
resistor when working with the
equipment.
Maintain the relative humidity above 30%. Working on this circuitry with a relative humidity
below 30% requires more extreme ESD precautions not specified in this document.
Use antistatic bags to store and transport any electronic components or circuit board
assemblies removed from this Camera. Use new antistatic bags as old antistatic bags can
lose their static protection after use.
2.4
Tripod Mounting Interface
The camera has a tripod mounting plate clamped to the bottom of the Camera. The Tripod mount
has five mounting threads (0.250-20UNC-2B) separated as shown in Figure 4. This provides two
center-to-center mountings, being 1.75
”
and 1
”
bolt patterns. Insure the mounting arm/fixture
supports one of these mounting bolt patterns.
Figure 4 - Tripod Mounting Locations
2.5
Main Rear Panel Signal Connector
The main signal input/output connector is located on the rear panel of the Camera as shown in
Figure 5.
