13
8) Disassemble the beater/auger by first removing the rubber
beater shaft (lip) seal, simply slide it off the shaft.
Continue disassembly by removing the beater IDLER. Pull
forward until the grooved portion of the shaft lines up with the
opening at the front of the beater/auger.
Finally, remove the beater/auger END PUSHER by pulling
straight and away from the beater. Dismount the scraper by
pulling it away from its housings.
9) The machine is now completely disassembled. The parts
should now be washed, rinsed and sanitized.
10) Wash all the parts in luke warm water (80-85 F) using a mild
detergent and the cleaning brushes provided in the START-
UP KIT.
DO NOT USE HOT WATER ON ANY OF THE PLASTIC PARTS
AS DAMAGE TO THE PARTS CAN RESULT.
Rinse the parts in luke warm water (80-85 F).
Place the parts in luke warm, sanitized water for 2 to 5
minutes. Use the sanitizer provided in the START-UP KIT
following the manufacturers directions.
11) Place the parts on a clean, sanitized counter area and allow
to air dry or disassemble wet. DO NOT TOWEL DRY OR
RINSE SANITIZED PARTS.
Figure 10
2) Rinse
3) Sanitize
4) Air Dry
1) Wash
