14
Mount the idler back.
When installed correctly, the idler (when turned) should rotate
freely. If the idler does not rotate, it is incorrectly installed and
must not be installed into the machine. Repeat the above
instructions.
5) Next, lubricate and install the beater lip seal by first lubricating
the beater/auger shaft with the lubricant included in the
START-UP KIT. Place three, 1/4" beads in equal distances
around the shaft as shown below.
Slide the rubber, beater lip seal onto the shaft.
Lubricate the end of the beater lip seal which is not lubricated by
placing three, 1/4" beads in equal distances around the seal
surface as shown below.
PART IV
ASSEMBLING THE FREEZER
Once the parts have been washed, rinsed and sanitized, the
freezer is ready to be re-assembled. Prior to beginning the re-
assembly procedure, sanitize your hands by submerging in the
sanitizing solution. Begin to re-assemble as follows:
A) Assembling the Beater/Auger
1) First, re-assemble the beater/auger assembly. Begin by
gathering the five parts needed to complete each assembly:
A) plastic “END PUSHER”, B) BEATER/AUGER, C) IDLER,
D) rubber, beater LIP SEAL, E) BLADE.
2) Mount the rubber seal onto the scraper by keeping the head
opposite to the groove.
3) Insert the scraper into the beater pins. Fasten the end
pusher. When installed correctly, the scraper should move
freely up and down, but should not come out away from
its seat.
B
A
C
E
D
