18
3) Slide the sleeve onto the tube. Please note that the slots in
the sleeve should be at the top of the tube when installed.
4) Slide the splash guard into the tube.
5) Lubricate the two O-rings with sanitary lubricant.
6) Insert the assembled tube into the hole at the bottom of the
mix tank. Press the tube down until it seats and the flange at
the base of the tube rests against the bottom of the mix tank.
The machine is now completely assembled and ready to be
sanitized.
PART V
SANITIZING THE FREEZER
Prior to install the machine with your soft serve product, the
machine must be sanitized. The frequency of cleaning and
sanitizing cycles must comply with local health regulations.
If uncertain about local regulations, contact your local Board of
Health.
Sanitizing the machine is most important. This procedure will
retard the growth of bacteria and insure excellent test results on
your product when examined by local Health and/or Agriculture
Departments.
To begin, you will need a clean pail, sanitizer (sample packets
included in the start-up kit), spatula (included in start-up kit), and
brush (plastic bristle).
Lubricate
