25
L1
L2
L3
L5
L4
570
571.1
571.2
PART VIII
ROUTINE, PERIODIC
CLEANING PROCEDURES
Cleaning and sanitizing schedules are governed by your State
or local regulatory agencies and must be followed accordingly.
A well planned cleaning schedule will eliminate excessive
waste of time and product within your organization.
On a designated day(s) of the week, allow the mix in the mix tank
to run as low as feasible.
Proceed to clean the machine, as follows:
1) Remove the Gravity Feed Tubes. Pull the tubes straight up
and out.
2) Push selector button 571.2 to select the “BEATER” position.
Let the machine run for 4 to 5 minutes.
3) Place a container or bucket under the spigot head. Slowly
pull
the handle down and remove remaining product
from the
cylinder.
4) Push selector button 571.1 to turn “OFF” the machine.
5) Fill hopper(s) and cylinder(s) with cold water (a mild non-
foaming dish washing detergent is recommended).
6) Push selector button to the “BEATER” position for one
minute. Push selector button to “OFF” position, drain water
by opening the spigot handle. Repeat this process until water
is clear.
571.1
