8
B) THE DISPENSE HANDLE
The Dispense Handle controls the flow, or extraction rate of
finished, soft serve product.
Pulling the handle in a downward direction will open the dispense
orifice. When the unit is in the “AUTOMATIC” mode, this will allow
finished product to be extracted and served.
C) PROXIMITY SWITCH
D) SAFETY SWITCH
Machine is equipped with a magnet molded into the spigot head.
If the spigot head is removed the magnet deactivates a safety
switch behind the front panel. The machine will not operate with
the spigot head removed. A message "MIP" will appear on the
display.
E) ELECTRIC CONTROL PANEL
The Electric Control Panel located behind the upper rear panel
of the unit, contains the controlling circuit to the components of
the machine. This panel is to be accessed only by trained,
experienced technicians.
Warning
Disconnect freezer from the source of electrical supply before
attempting to service.
In AUTOMATIC function the proximity switch pos. 152 starts the
motor when the hand, handling cup or cone, is in the range of the
sensitivity preset by Coldelite.
Note: Keep the sensor always clear and clean.
Adjusting Proximity Switch
The proximity switch pos. 152 has been preset at the factory and
its range is approximately 9 inches.
If modification is required, contact authorized service agency as
this operation must be carried out by specialized technicians.
1
2
3
4
5
6
7
8
9
152
