16
You are now ready to install the dispensing head
assembly onto the front of the freezer.
Finger tighten the four metal dispensing head-
retaining knobs.
Hand tighten the knobs in a criss-cross pattern as
shown below.
B
D
C
A
C) Assembling the Gravity Feed Tubes
Locate the parts needed to assemble the gravity
feed tubes. This should include: A) Splash guard,
B) Orings (2per), C) Outer regulating sleeve, D)
Center gravity feed tube
Next, slide the two orings onto the center gravity
feed tube oring grooves.
Slide the outer regulating sleeve onto the center
feed tube. Make sure that the two finger hooks are
at the top of the feed tube (farthest away from the
orings at the bottom).
